Automatic washing machine common faults and solutions

- Mar 26, 2019-

1. There is no water in the washing machine of the automatic washing machine, but the computer board shows that there is water in the water level. At this time, the water will not enter the washing machine. It is necessary to see if there is any residue in the water level gauge. If any, the water is removed first. To remove the water, if it still does not eliminate the fault, then look at the water level sensor is damaged, if it is damaged, then change the water level sensor.
2, the automatic washing machine has put water but can not heat, the indicator light is not bright, should check the water temperature set temperature, the water has reached the set temperature, you can set the temperature to a higher point, so the water can be heated .
3, automatic washing machine computer board has a signal, but a certain execution command does not respond, the first may be the computer output interface plug-in loose, at this time the plug-in is connected, if there is no response, then check the output fuse on the computer board is burned, If it burns out, you can replace the fuse.
4. The automatic washing machine is very noisy and vibrating during washing. Firstly, consider whether the automatic washing machine is placed smoothly. When installing the automatic washing machine, the washing machine should be placed on the level ground, and then see if the cloth is evenly placed. Whether there is a non-clothing item in the washing machine or in the washing cloth.
5. When the automatic washing machine is washing, the rotation speed of the drum is very slow. First check whether the motor is running normally. Then check if the V-belt pulley has slack or insufficient toughness, and replace or repair according to the situation.
6. The automatic washing machine suddenly trips in the middle and high dehydration. Firstly, it is necessary to see if the drainage is not smooth and cause current overload. Keep the drain pipe and the launching channel unobstructed, there is a certain drop, and then check the acceleration or deceleration time set by the inverter. Not too short, reinstall the factory setting to set the parameters of the inverter

These automatic washing machines do not operate intermittently, and it is inevitable that loss occurs. Generally, the glitch can solve it by itself, but if you can't solve it yourself, you must contact the manufacturer's after-sales service center in time to strive for the loss. drop to lowest.